Franklin Electric FLS-400 Manual

SAFETY WARNINGS
BEFORE OPERATING OR IN-
STALLING THIS PUMP, READ
THIS MANUAL AND FOLLOW ALL
SAFETY RULES AND OPERAT-
ING INSTRUCTIONS.
SAFETY
CAREFULLY READ THE SAFETY
MESSAGES IN THIS MANUAL AND ON
THE PUMP.
CAUTION
• Review instructions before operating.
WARNING - ELECTRICAL PRECAUTIONS
• All wiring, electrical connections, and system ground-
ing must comply with the National Electrical Code
(NEC) and with any local codes and ordinances. Em-
ploy a licensed electrician.
WARNING - RISK OF ELECTRICAL SHOCK
• Have an electrician provide electrical power to the
motor plug receptacle.
• Always disconnect plug from power source before
handling.
• This product is furnished with a three prong plug
for grounding, connect only to properly grounded
receptacle.
• Do not under any circumstances remove ground
plug.
1) Never make adjustments with the power connected.
Always disconnect your pump from the electrical outlet
before beginning any service procedures.
2) Do not stand in damp area when operating or servicing
the pump. Always wear rubber boots when you must
unplug the pump from the power supply. Because of
These pumps are designed for continuous duty with stable
operating performance to carry dirty or clean water, for
drainage and irrigation purpose. Also, the maximum solids
size must not be greater than the pump capability. This
pump is for use with water only,
SUBMERSIBLE
DEWATERING PUMPS
FLS-400, FS-750
• Keep electric plug dry.
• Do not lift pump using cord.
• Not investigated for use in swimming pool area.
• A ground fault interrupter (GFI) protected circuit is
recommended for use with any electrical appliance
operating in or near water.
• Do not run pump dry.
ELECTRICAL SAFETY TIPS
possible electric shock, always be aware of others in
proximity of pump during operation.
3) Do not put your fi nger into the fuse socket - it could be
fatal.
4) Never remove the round pin from your plug; this is the
ground and is there for your safety.
APPLICATION
NOT FOR USE IN EFFLUENT OR SEWAGE APPLICA-
TIONS! NOT TO BE INSTALLED IN LOCATIONS CLAS-
SIFIED AS HAZARDOUS IN ACCORDANCE WITH THE
NATIONAL ELECTRICAL CODE (ANSI/NFPA).