Advertisement
INSTRUCTIONS FOR ASSEMBLY
18.
Apply Loctite® 302-43 to the set screw from the
motor coupling kit and reinstall the screw on the
shaft coupling. Use 5 mm Allen wrench to tighten.
19.
Once secured, identify the cable guard included with
the corresponding pump model.
20.
Cable Guard Assembly: For 6" pumps continue to
Step 21. For 8" pumps, go to Step 34.
21.
Orient the cable guard so the angled tab is on the
motor bracket end and the top two tabs extend past
the pump's discharge.
22.
Install the cable guard tabs closest to the
motor bracket.
23.
Gently tap the side of the cable guard to drive one of
the tabs under the strap.
• Do not tap the tabs.
18
23
21
22
21
9
Advertisement
