Setting Up The Hardware; Running The Out-Of-Box Demo; Hardware Setup; Out-Of-Box Demonstration - Texas Instruments CAPTIVATE-EMC Getting Started Manual

Getting Started
4.1

Setting up the Hardware

CAPTIVATE-EMC is designed to accommodate various powering methods, including through the 20-pin
connector from CAPTIVATE-PGMR and a banana jack connector from a DC power supply.
Do not enable both power supplies at the same time because this can damage
the CAPTIVATE-PGMR board.
4.2

Running the Out-of-Box Demo

By default after power up, the CAPTIVATE-EMC development kit runs system initialization and capacitive
touch calibration. When this initialization is finished, the POWER LED illuminates, the RUN LED blinks, all
other LEDs are off, and the beeper is off. Touch a button on the CAPTIVATE-EMC panel to turn on or turn
off the indicator LED above that button. The DETECT LED illuminates and the speaker beeps when a
button is touched.
6
CAPTIVATE-EMC Getting Started Guide
CAUTION
Figure 5. Hardware Setup
Figure 6. Out-of-Box Demonstration
Copyright © 2019, Texas Instruments Incorporated
www.ti.com
SLAU821 – October 2019
Submit Documentation Feedback