Dzoom_Pos - Canon WUX6000 User Commands

DZOOM_POS

Zoom display position
Format
Setting Command
Response
Reference Command
Response
<DZOOM position No / Y:Number> is a signed integer indicating the central position of the enlarged
input image.
Environment
Power mode restriction
LAN
SL0 SL1 SL3 PM ON
No No No No Yes
Remarks
(1) This command is identical to pressing the arrow keys to move while DZOOM is enabled,
however, the position can be specified in more detail.
(2) If a position outside the range is specified, the position is automatically moved to the nearest
position within the range.
(3) 0 for <DZOOM position No / Y:Number> indicates the center position of the input image.
(4) Positive direction for <DZOOM position No / Y:Number> corresponds to RIGHT and UP keys,
and negative direction corresponds to LEFT and DOWN keys.
(5) The numerical value for <DZOOM position No / Y:Number> represents units in pixels of the
input image.
* For example, in a case where an input image of XGA (1024 x 768) size is enlarged twice the
size (range of 512 x 384 is displayed), up to ±256 for <DZOOM position No:Number>, and up
to ±192 for <DZOOM position Y:Number> can be specified.
Example
(Control)
> DZOOM_POS=100,200
< i:OK
(Reference)
> GET=DZOOM_POS
< g:DZOOM_POS=100,200
Note: '>' indicates a command; '<' indicates a response.
DZOOM_POS=<DZOOM position No:Number>,
<DZOOM position Y:Number>
i:OK
GET= DZOOM_POS
g:DZOOM_POS=<DZOOM position No:Number>,
<DZOOM position Y:Number>
Note: See "Error list" for any response other than the above.
RS-232C
ST PM ON D-RGB
No No Yes Yes
-41-
WUX6000 User Commands
Input
A-RGB COMP HDMI LAN
Yes Yes Yes Yes
USB None
Yes No