Communication Specifications - Canon WUX6000 User Commands

2. Communication Specifications

Communication Specifications
The projector can be controlled via RS-232C or LAN cable connection.
PC
PC
Item
Connection
system
Connection
signal line
Connection
cable
送信データ Send Data
受信データ
Receive Data
Signal Ground
信号用設置
* Signal lines other than the three SD, RD, and SG lines are not used in the projector.
* Loop back its own signals on the PC side as necessary.
* To use the LAN connection, the network function on the projector must be turned on.
In addition, to allow network communication between the PC and projector, connect cables between the
devices, and set the IP addresses, subnet masks, and other network parameters.
PC - Projector connection configuration
LAN PORT
Network connection
COM PORT
RS-232C
crossover cable
RS-232C connection
Specifications
PC and projector connected on a "1:1"
basis
3-line connection of SD, RD, and SG
9-pin RS-232C cable (crossover)
SD SD
RD RD
SG SG
LAN PORT
PROJECTOR
SERVICE
PORT
Item
Connection
system
Connection
signal line
Connection
cable
LAN
Send Data 送信データ
受信データ
Receive Data
Signal Ground
信号用設置
-2-
WUX6000 User Commands
LAN connection
Specifications
TCP / IP connection
Straight when connecting via network
LAN cable
1000BASE-T
100BASE-TX
10BASE-T