Main - Canon WUX6000 User Commands

MAIN

Unit control panel emulation
Format
Setting Command
Response
Reference Command
Response
< Side control emulation button parameters:ID >
Parameter
POWER POWER
POWER_OFF -
MENU MENU
LENS LENS
INPUT INPUT
AUTOPC AUTOPC
KEYSTONE KEYSTONE
UP
UP
UP+REP
DOWN
DOWN
DOWN +REP
LEFT
LEFT
LEFT +REP
RIGHT
RIGHT
RIGHT +REP
OK OK
*-REP -
Environment
Power mode restriction
LAN
SL0 SL1 SL3 PM
No Yes Yes Yes
Remarks
(1) Parameters with "+REP" indicates "Button press start" (same state as when the front panel
button is held down).
Be absolutely sure to send the '*-REP' parameter, and end the button pressing last of all.
The button pressing is ended in the cases below as well.
① When buttons on the panel or the remote are operated
② When some command has been received
(2) When ceiling mount setting is made, functions of UP/DOWN/LEFT/RIGHT buttons on the
unit control panel are reversed. But the "MAIN" command's UP/DOWN/LEFT/RIGHT are
unaffected and always work in the same way as when installed on the floor.
(3) Adjust the time between each button press using the application.
(4) When a button press request is accepted properly, the projector returns "i:OK" even when the
function is inexecutable.
(5) All parameters except "Power" are invalid during standby mode.
MAIN=<Side control emulation button parameters:ID>
i:OK
-
-
Meaning
Operation
Power OFF
Button press start
Button press start
Button press start
Button press start
Button press end
RS-232C
ON ST PM ON D-RGB
Yes Yes Yes Yes Yes
-63-
WUX6000 User Commands
Note: See "Error list" for any response other than the above.
Remarks
Input
A-RGB COMP HDMI
Yes Yes Yes
LAN USB None
Yes Yes Yes