Canon WUX6000 User Commands page 78

DZOOM_M
DZOOM -
DZOOM_M+REP
VOL_P VOL +
VOL_P+REP VOL +
VOL_M VOL -
VOL_M+REP VOL -
MUTE MUTE
FN FN
IMAGE IMAGE
FREEZE FREEZE
BLANK BLANK
GAMMA GAMMA
SPLIT SPLIT
ECO ECO
*-REP -
Environment
Power mode restriction
LAN
SL0 SL1 SL3 PM ON
No Yes Yes Yes Yes Yes Yes Yes
Remarks
(1) A parameter with '+REP' signifies "button press start". (This is the same as the status in
which the remote control button is held down.)
When executing these commands, be sure to send '*-REP' at the end to finish the button press.
The button pressing is ended in the cases below as well.
① When buttons on the panel or the remote are operated
② When some command has been received
(2) When a button press request is accepted properly, "i:OK" is returned.
(without notifying the resulting execution of button operation)
Example
(Setting)
>RC=POWER
< i:OK
Note: '>' indicates a command; '<' indicates a response.
Button press start
Button press start
Button press start
Button press end
RS-232C
ST PM ON D-RGB A-RGB COMP HDMI
Yes Yes
-75-
WUX6000 User Commands
Input
LAN USB
Yes Yes Yes Yes
None
Yes