LogTag Recorders TRED30-16R Product User Manual page 9

Starting the Recorder
Push button start
The recorder must be in
Current time and the
READY
Press and hold the
START
is shown in addition to
READY
Then disappears:
READY
Once disappears, release the button within two seconds.
READY
will also disappear, and the
STARTING
The TRED30-16R now records temperature data.
The recorder will not start if you...
... release the button before
... keep holding the button for more than 2 seconds after
disappears.
Distributed by MicroDAQ
Page 9 of 17
mode for it to be started.
READY
symbol are shown.
button. First,
/CLEAR/STOP
:
symbol will be shown.
disappears
READY
Push button start, quickstart disabled
Again, the recorder must be in
Press and hold the
symbol starts flashing for about 4 seconds. Then the symbol remains on
permanently for 2 seconds. If you release the button during this time,
The
STARTING
recorder starts taking temperature readings.
If the button is released earlier than 4 seconds or later than 6 seconds,
the display shows
READY
www.MicroDAQ.com
TRED30-16R Product User Guide, Revision 1.4, copyright © 2004-2017,
mode for it to be started.
READY
START
/CLEAR/STOP
symbol is shown, the
STARTING
again, and the recorder does not start.
READY
button. The
STARTING
symbol goes off and the
(603) 746-5524
®
LogTag Recorders . All rights reserved.