... release the button before the
... keep holding the button for more than 2 seconds after the
symbol disappears.
... release the button before
... if you keep holding the button after
permanently on for more than 2 seconds.
If an ALARM is present ( ) and the
button
function is enabled, you will need to clear the alarm first
before you can stop the recorder. Please see
page 11 for more information on how to clear an alarm.
Once the recorder has stopped, the alarm status will no longer be
indicated with a cross or a tick symbol, and the audible alarm will
turn off.
Resetting the Recorder
You can reset a recorder back to its original
Once re-set, recording can be started again as described in
Recorder
on page 9.
Note that when performing this procedure all recordings and
statistics stored in the recorder are deleted and cannot be recovered.
Please ensure your data has been saved!
For this process to work, the recorder must be in the
Press and hold the
l
When the
symbol remains permanently on, release the
READY
l
button within 2 seconds. The recorder is now ready to be started
again.
The ability to reset a recorder is enabled or disabled in the
Options
dialogue when configuring the TRED30-16R via LogTag
Analyzer (see
Advanced Configuration Options
Hibernating a TRED30-16R
When hibernated, the recorder's power consumption is near zero and
the life of the battery approaches its shelf life (typ. 5 or more years).
Distributed by MicroDAQ
Page 15 of 17
symbol disappears
remains permanently on, or
STOPPED
remains
STOPPED
Clear alarm by pressing STOP
Clearing an Alarm
state.
READY
STOPPED
button. The
symbol will flash.
READY
on page 6).
This is useful for conserving battery life when the recorder is not used
for extended periods .
TRED30-16R recorders are placed into Hibernation using LogTag
Analyzer by clicking Hibernate on the LogTag menu.
The display shows SLP for a few seconds, before turning itself off.
on
A hibernated recorder has no active display, however a button press will
wake the recorder up briefly. The display will show:
the low battery symbol
l
the text not rdY if the battery is OK, and the recorder can be re-
l
activated at a later point.
Starting the
state.
A hibernated recorder can be activated again by pressing and holding
the
and
time the text not rdY appears and the
Release the buttons when the flashing stops.
You can re-activate a recorder with a low battery, however it is not
recommended to commence another trip.
Note: The real time clock is not running in a hibernated recorder and
must be set up if the recorder is manually activated. Therefore, the
CLOCKADJ
Display Clock
Advanced
Once the clock has been set, the recorder is ready to be started again.
®
www.MicroDAQ.com
TRED30-16R Product User Guide, Revision 1.4, copyright © 2004-2017,
if the battery requires replacing.
buttons together for a period of 6 seconds. During this
READY
procedure is automatically invoked (see
on page 8).
(603) 746-5524
LogTag
®
symbol flashes.
Adjusting the
®
Recorders
. All rights reserved.
Need help?
Do you have a question about the TRED30-16R and is the answer not in the manual?