Step 4: Connect External Devices And Cables; Connecting The Ja2500 Appliance To A Management Console - Juniper Junos Space JA2500 Quick Start Manual

JA2500 Junos Space Appliance Quick Start

Step 4: Connect External Devices and Cables

Connecting the JA2500 Appliance to a Management Console

14
Attach the plastic safety cover.
9.
Close the input circuit breaker.
10.
The JA2500 Appliance powers on when you supply power to the power supply module.
If the power supply module is correctly installed and functioning normally, the LED on
the power supply module displays green when the power supply module is powering the
appliance, and amber when the power supply module is in standby mode (not powering
the appliance).
Connecting the JA2500 Appliance to a Management Console on page 14
Connecting the JA2500 Appliance to the Network on page 15
Every JA2500 appliance has a console port with an RJ-45 connector that you can use to
connect the appliance to the management console or to a console server. An RJ-45 cable,
as shown in Figure 9 on page
with the appliance.
Figure 9: Ethernet Cable Connector
To connect the appliance to a management console, do the following:
Connect the RJ-45 to DB-9 serial port adapter to the serial port of the management
1.
device (laptop or PC) that you will use to access the Junos Space CLI.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and
you want to connect your laptop or PC directly to the appliance, use a
combination of the RJ-45 to DB-9 female adapter supplied with the
appliance and a USB to DB-9 male adapter. You must provide the USB
to DB-9 male adapter.
Connect one end of the Ethernet cable into the console port (labeled
2.
the front panel of the appliance.
Connect the other end of the Ethernet cable into the RJ-45 to DB-9 serial port adapter.
3.
14, and an RJ-45 to DB-9 serial port adapter are supplied
Copyright © 2018, Juniper Networks, Inc.
CONSOLE ) on