Kenwood KTF-2010 Instruction Manual page 4

System connection
Connection of the Audio components/Connection of the system control cord
4
M ake connections as show n below.
When connecting the related system components, refer also
to the instruction manuals of the related components.
Do not plug in the pow er lead until all connections are com-
pleted.
Caution regarding placement
To maintain proper ventilation, be sure to leave a space around the
unit (from the largest outer dimensions including projections) equal
to, or greater than, show n below.
Left and right panels: 10 cm
Rear panel: 10 cm
KTF-3010 only
The system control connection
Connecting system control cords after connecting a Kenw ood audio component system lets you take advantage of convenient system
control operations.
There are tw o Kenw ood system control modes. M ake connections according to the groups of terminal symbols show n below.
[SL16] M ode : for
[XS8] M ode : lets you combine F, f, and ƒ terminals
This unit is compatible w ith both [SL16] and [XS8] modes. It comes from the factory set to the [SL16] mode. To sw itch to the [XS8] mode,
follow the instructions in "Sw itching from [SL16] to [XS8]".
1. [SL16] equipment cannot be combined w ith [XR], [XS], and [XS8] equipment for system
operations. If your equipment consists of this kind of combination, please do not connect
Notes Notes
any system control cords. Even w ithout system control cords, normal operations can be
carried out w ithout affecting performance.
2. If your amp or receiver does not have a system control terminal, do not connect any
system control cords to the system control terminals on the other components.
3. Do not connect system control cords to any components other than those specified by
Kenw ood. It may cause a malfunction and damage your equipment.
4. Be sure the system control plugs are inserted all the w ay in to the system control termi-
nals.
1.Connect all cords firmly. If connections are loose, you may lose the sound or interconnectable system control operations may not w ork.
2.When plugging and unplugging connection cord, be sure to first remove the pow er cord from the AC outlet. Plugging / unplugging
Notes Notes
connection cords w ithout removal of the pow er cord can cause malfunctions or damage to the unit.
Downloaded from: http://www.usersmanualguide.com/
Audio cord
OUTPUT
ANTENNA
FM 75Ω GND AM
L
R
A B
terminals only
M alfunction of microcomputer
If operation is not possible or erroneous display ap-
pears even though all connections have been made
properly, rest the microcomputer referring to "In case
of difficulty".
TUNER
Pre-main amplifier
L
STEREO INTEGRATED AMPLIFIER KAF-3010R
R
CD PHONO TUNER
ON/STANDBY
POWER
ON OFF
PHONES A SPEAKER B BASS TREBLE BALANCE
| { | { L R
SYSTEM
CONTROL
ƒ
SL16 XS 8
No m atter to w hich of the tw o term inals the con-
nection is m ade, the use m ethod is the sam e.
KTF-3 0 1 0 / KTF-2 0 1 0 (En)
SYSTEM CONTROL
ƒ
SL16 XS 8
VOLUME CONTROL
SOURCE DIRECT
TAPE MD
MIN MAX
INPUT SELECTOR
MUTING LOUDNESS
T R A I T
thermally reactive advanced instantaneous transistor
System control cord
^
To w all AC
outlet