Download
 Share
 Print this page
  1. Manuals
  2. Brands
  3. Kenwood Manuals
  4. Car Receiver
  5. KTF-2010
  6. Service manual

Kenwood KTF-2010 Service Manual

Am-fm stereo synthesizer tuner
Hide thumbs

Advertisement

Quick Links

Download this manual See also: Instruction Manual
Table of Contents
www.freeservicemanuals.info
AM-FM STEREO SYNTHESIZER TUNER
KTF-2010/3010
SERVICE MANUAL
Illustration is KTF-2010.
KENWOOD badge
(B43-0302-04)
ON/STANDBY
Metallic cabinet
(A01-3559-01)
How to reset the microcomputer
The microcomputer may malfunction (impossibility operation,erro-
neous display,etc.)when the power cord is unplugged and plugged
in again while the unit is in ON mode with the Key pressed or due
to other extern al causes.In this case,execute the procedure on the
right to reset the microcomputer and return the unit to the normal
condition
AM-FM STEREO SYNTHESIZER TUNER KTF-2010
HIGH
WIDE
NARROW
ACTIVE
ANT A/B
RECEPTION
IF BAND
RF ATT
RF
PTY/
MEMORY
TA/NEWS
PTY SEARCH
DISPLAY
1
Panel
(A60-1336-02)
Phono jack
(E63-0068-15)
OUTPUT
ANTENNA
FM 75Ω
GND
AM
L
R
Lock terminal board
(E20-0321-05)
Global electronic heritage manuals
Front glass *
(B10-)
BLEND
ATT
AUTO/MANUAL
+
10/CLEAR
2
3
4
5
6
7
8
9
Knob
(K29-6882-03)
Miniature phone jack
(E11-0188-05)
SYSTEM
CONTROL
ƒ
SL16 XS 8
Slide switch
(S31-2132-05)
Unplug the power cord form the wall outlet.
While pressing and holding the (ON/STANDBY) key,
plug the AC cord into the wall outlet again
•Resetting the microcomputer clears the memory you entered and
returns in to the initial condition when the unit left the factory.
© 1998-1/B51-5407-00 (K/K) 2106
TUNING/MULTI CONTROL
BAND
P. CALL
DOWN
0/CHARA
Knob
(K29-6883-04)
AC power code*
(E30-)
Power cord bushing
(J42-0083-05)
* Refer to parts list on page 18.
30/3/2014
UP

Advertisement

loading

  Also See for Kenwood KTF-2010

Kenwood KTF-2010 Instruction Manual
Kenwood KTF-2010 Instruction Manual 21 pages
KENWOOD KTF-2010 Instruction Manual
KENWOOD KTF-2010 Instruction Manual 20 pages
Kenwood KTF-2010 Service Manual
Kenwood KTF-2010 Service Manual 20 pages

  Related Manuals for Kenwood KTF-2010

  Summary of Contents for Kenwood KTF-2010

  • Page 1 30/3/2014 AM-FM STEREO SYNTHESIZER TUNER KTF-2010/3010 SERVICE MANUAL © 1998-1/B51-5407-00 (K/K) 2106 Illustration is KTF-2010. KENWOOD badge Front glass * (B43-0302-04) (B10-) AM-FM STEREO SYNTHESIZER TUNER KTF-2010 HIGH BLEND TUNING/MULTI CONTROL WIDE NARROW ACTIVE ANT A/B RECEPTION IF BAND RF ATT...

  • Page 2: Accessories / Controls

    Signal indicator Receiving band indicator Frequency display Magahertz indicator Preset channel display EON indicator STATION NAME display Display 3 4 5 AUTO/MANUAL with the KTF-2010 AM-FM STEREO SYNTHESIZER TUNER KTF-3010 HIGH BLEND TUNING/MULTI CONTROL WIDE NARROW ACTIVE ANT A/B RECEPTION...

  • Page 3: External View

    30/3/2014 KTF-2010/3010 EXTERNAL VIEW Illustration is KTF-3010. KENWOOD badge Front glass (B43-0302-04) (B10-2449-03) AM-FM STEREO SYNTHESIZER TUNER KTF-3010 HIGH BLEND TUNING/MULTI CONTROL WIDE NARROW ACTIVE ANT A/B RECEPTION IF BAND RF ATT BAND PTY/ MEMORY TA/NEWS PTY SEARCH DISPLAY...

  • Page 4: Circuit Description

    30/3/2014 KTF-2010/3010 CIRCUIT DESCRIPTION 1. Test mode •The FL shows the normal mode by pressing the key and the switch except the MEMORY and the Slide switch. 1-1. Test mode with the main unit keys Display ex. a) Setting procedure...
  • Page 5 30/3/2014 KTF-2010/3010 CIRCUIT DESCRIPTION 1-3. Initial settings RDS DISPLAY MODE : FREQUENCY DISPLAY a) Setting procedure MODE TA / NEWS / TA, NEWS : OFF • If the unit has a back-up function, hold down the POWER ACTIVE RECEPTION : OFF key and plug the AC power cord.
  • Page 6 30/3/2014 KTF-2010/3010 CIRCUIT DESCRIPTION 2. Microprocessor : µPD780206GF031 (IC9) 2-1. Pin connection ED 1 FL DISPLAY HIGH BLEND LED ATT LED NARROW LED KEY MATRIX WIDE LED IC 7 Q1, 2 IC 9 ANTENNA A/B RDS DEMODULATOR IC IC 2...
  • Page 7 30/3/2014 KTF-2010/3010 CIRCUIT DESCRIPTION 2-2 Pin function Pin No. Pin Name Descriptions – Power supply(+5V) – No use Chip enable L : CE detection /RESET Microprocessor reset L : RESET 11,12 X1,2 Main clock oscillator IC(Vpp) – Connect to VSS...
  • Page 8 When TUNER PCB (X05-) is disconnected from main unit,connect PCB's GND (ANT shield plate) and main unit chassis using aligator clip. Then, check TUNER PCB. TUNER SETTINGS KTF-2010 : AUTO, 98.0MHz KTF-3010 : AUTO : WIDE, RF ATT OFF : 98MHz OUTPUT...
  • Page 9 www.freeservicemanuals.info 30/3/2014 (X05-484X-XX) (A/4) +12V +12V +12V C27 0.01 R44 100 R137 C249 10P Q12~15 100P W: 0V 3.3K R24 51K A1 (W02-2512-05) KT-2010 (M1,X1) TYPE 3.5V N:4.3V IF AMP (ANT A) SENSITIVITY RF AMP DISTORTION 0-150 R40 1.8K R41 1.8K +12V W119 C2 12P...
  • Page 10 1.5V +12V IFT : R12 P194A 3.2V 12.3V 2.4V 2.8V (12.4V) 3.9V (2.5V) (2.2V) (J)TYPE ONLY AM STEREO (3.8V) DE-EMPHASIS KTF-2010/3010 (1/2) C197 0.01 R269 15K 12.3V R261 (12.4V) SGND DISCRIMINATOR BUFFER R262 NOISE METER 100K BUSY 1.2V R175 C121...
  • Page 11 The DC voltage is an actual reading measured with : 10-BT-202GX a high impedance type voltmeter as the AM/FM sig- nal generator is specified to the conditions as KTF-2010 (X05-484X-XX) W228 shown in the list below. The measurement value DESTINATION...

  • Page 12: Pc Board(Component Side View)

    www.freeservicemanuals.info 30/3/2014 PC BOARD(Component side view) OUTPUT FM75Ω SYSTEM CONTROL X05-484X-XX A/4 C118 SL16 C109 R403 R402 C128 W237 HI-BLEND R102 R103 SEP. C185 C195 X05 C/4 R297 C193 R114 R150 STANDBY X05 D/4 X05 B/4 TUNING /MULTI CONTROL Refer to the schematic diagram for the value of resistors and capacitors. Global electronic heritage manuals...
  • Page 13 www.freeservicemanuals.info 30/3/2014 3x8 (BLK) : N89-3008-45 2.6x8 : N82-2608-46 3x23 : N89-3023-46 : N09-1445-05 SYSTEM CONTROL OUTPUT SL16 XS8 GND AM ANTENNA FM 75 ACTIVE RECEPTION BAND S 6 S 5 S 4 S 3 X05-484 DISPLAY MEMORY BAND (A/4) TUNING MODE 10/CLEAR...
  • Page 14 Ref. No Parts No. Description Ref. No Parts No. Description ress Parts nation marks ress Parts nation marks KTF-2010/3010 (KTF2010: E,M1,X1,T1/KTF3010: E1,T2) T90-0195-05 LOOP ANTENNA T90-0809-05 LEAD WIRE ANTENNA A01-3559-01 METALLIC CABINET A22-1793-01 SUB PANEL TUNER (X05-4842-70) A60-1336-02 PANEL A60-1356-02 PANEL...
  • Page 15 www.freeservicemanuals.info 30/3/2014 New Parts New Parts Parts without Parts No. are not supplied. Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Teile ohne Parts No.
  • Page 16 www.freeservicemanuals.info 30/3/2014 New Parts New Parts Parts without Parts No. are not supplied. Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Teile ohne Parts No.
  • Page 17 www.freeservicemanuals.info 30/3/2014 New Parts New Parts Parts without Parts No. are not supplied. Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Teile ohne Parts No.
  • Page 18 www.freeservicemanuals.info 30/3/2014 New Parts New Parts Parts without Parts No. are not supplied. Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Teile ohne Parts No.

  • Page 19: Specifications

    30/3/2014 KTF-2010/3010 SPECIFICATIONS KTF-2010 KTF-3010 FM tuner section FM tuner section Tuning frequency range......87.5 MHz ~ 108 MHz Tuning frequency range......87.5 MHz ~ 108 MHz (For Russia) ........65.0 MHz~74 MHz (For Russia) ........65.0 MHz~74 MHz 87.5 MHz~108 MHz 87.5 MHz~108 MHz...
  • Page 20 30/3/2014 KTF-2010/3010 KENWOOD follows a policy of continuous advancements in development. For 14-6,Dogenzaka 1-chome, Shibuya-ku, Tokyo, 150 Japan this reason specifications may be changed without notice. KENWOOD SERVICE CORPORATION P.O BOX 22745, 2201 East Dominguez St., Long Beach, CA 90801-5745, U.S.A.

This manual is also suitable for:

Ktf-3010