Vega VEGABAR 87 Operating Instructions Manual page 39

Menu item
Scaling
Current output
Copy instrument settings
Scaling (1)
Scaling (2)
VEGABAR 87 • 4 ... 20 mA
Parameter
Scaling size
Scaling format
Current output - Meas.
variable
Current output - Adjust-
ment
The instrument settings are copied with this function. The following
functions are available:
•
Read from sensor: Read data from sensor and store into the
display and adjustment module
•
Write into sensor: Store data from the display and adjustment
module back into the sensor
The following data or settings for adjustment of the display and ad-
justment module are saved:
•
All data of the menu "Setup" and "Display"
•
In the menu "Additional adjustments" the items "Reset, Date/Time"
•
The user-programmable linearization curve
The copied data are permanently saved in an EEPROM memory in
the display and adjustment module and remain there even in case of
power failure. From there, they can be written into one or more sen-
sors or kept as backup for a possible electronics exchange.
Note:
Before the data are saved in the sensor, a safety check is carried out
to determine if the data match the sensor. In the process the sensor
type of the source data as well as the target sensor are displayed. If
the data do not match, a fault message is outputted or the function is
blocked. The data are saved only after release.
In menu item "Scaling" you define the scaling variable and the scaling
unit for the level value on the display, e.g. volume in l.
In menu item "Scaling (2)" you define the scaling format on the display
and the scaling of the measured level value for 0 % and 100 %.
6 Set up with the display and adjustment module
Default value
Volume in l
0 % corresponds to 0 l
100 % corresponds to 0 l
Lin. percent - Level
0 ... 100 % correspond to 4 ... 20 mA
39