15. PRESETTING OF COPY MODES
JOB PRESET is a feature that allow s another job to be set w hile a current job is being done.
You can preset the next copy m odes during a copy run.
You cannot preset the next copy m odes during the scanning of the originals.
1
Press the JOB PRESET key during a copy
run.
2
Set the next copy modes.
3
Place the originals on the original feed tray
and press the START key.
4
The preset job w ill start w hen the current
copying is finished.
. To cancel the preset copy m odes, press the
JOB CANCEL key.
Note: If the STOP key is pressed or the copy
run is interrupted due to running out of
paper, etc. during job presetting, the set
m odes are cleared. Set the desired copy
m odes again after the copy operation
restarts.
Downloaded from:
http://www.usersmanualguide.com/
53