Table of Contents
Advertisement
PRECAUTIONS
1. INSTALLATION
1
The AR-650/ 800 should be installed by a qualified service technician.
Note: The packing m aterial should be disposed of properly.
2
To obtain the best possible results, this copier should be used in conjunction w ith a
dedicated AC pow er line at the follow ing ratings:
115V–60 Hz, 16 A
Notes:
1. The use of other appliances or other equipm ent on the sam e line as this copier m ay adversely
affect perform ance and copy quality.
2. Be sure to use a 3-conductor, grounded w all outlet.
3. In areas w here a 2-pin plug is used, the copier m ust be grounded for safety.
Never ground it to a gas pipe, a w ater pipe, or any other object not suitable for grounding.
3
After a suitable place has been selected for the installation of the AR-650/ 800, please
do not change it. Avoid excessive heat, dust, vibration and direct sunlight. Also,
provide proper ventilation as the copier emits a small amount of ozone.
Notes:
1. Recom m ended environm ental range for use is as follow s:
• Tem perature:
• Hum idity:
2. To insure optim al operation, allow clearances of at least 32" on the left, 32" on the right
and 4" in the rear (refer to the illustration below ).
The socket-outlet shall be installed near the equipment and shall be easily accessible.
Downloaded from:
http://www.usersmanualguide.com/
10~30˚C/50~86˚F
20~85% RH
32 inches
4 inches
32 inches
5
Advertisement
Table of Contents
