Table of Contents
Advertisement
Caution
Make certain that you are properly grounded when you handle components internal to
the appliance to protect against electrostatic discharge damage to the appliance. Use
the grounding wrist strap included in the battery replacement kit.
To install the battery
1. Use Check Point Network Voyager or the CLI to perform an orderly shutdown of the IP150.
For information about how to access Network Voyager and the related reference materials,
see
Press the power switch, located on the back of the appliance, to turn off power to the
appliance.
2. Remove the power cord from the IP150 appliance, and remove the appliance from the rack.
3. Turn the appliance right-side up and place it on a safe and protected work surface.
4. Remove the three top-cover screws and slide the cover back to remove it from the appliance.
Check Point IP150 Security Platform Installation Guide
"Using Check Point Network Voyager"
on page 29.
Replacing the Battery
00667
51
Advertisement
Table of Contents
