Before You Start - Nokia Check Point IP150 Installation Manual

5
Caution
To protect the appliance and the compact flash memory from electrostatic discharge
damage, make sure you are properly grounded before you touch these components.
Use a grounding wrist strap and follow the instructions provided with the wrist strap
before you handle the components or open the appliance. If you do not have a
grounding wrist strap, make sure you are properly grounded before you touch any
electronic component.
You must perform an orderly shutdown of the appliance and turn the power off whenever you
remove the chassis tray assembly to service internal components.
Caution
You risk damage to the appliance or loss of data if you do not use the following
procedure when you replace the compact flash memory.

Before You Start

To replace the compact flash card in your appliance, you need the following:
Physical access to the appliance
A Check Point-approved compact flash card
Access to the appliance through Network Voyager
A Phillips-head screwdriver
To replace compact flash memory in your appliance
1. Use Check Point Network Voyager or the CLI to perform an orderly shutdown of the IP150.
For information about how to access Network Voyager and the related reference materials,
see
Press the power switch, located on the back of the appliance, to turn off power to the
appliance.
2. Remove the power cord from the IP150 appliance, and remove the appliance from the rack.
3. Turn the appliance upside down and place it on a safe and protected work surface
34
"Using Check Point Network Voyager" on page 29.
Check Point IP150 Security Platform Installation Guide