Before You Start - Nokia Check Point IP150 Installation Manual

Caution
To protect the appliance and the encryption accelerator card from electrostatic
discharge damage, make sure you are properly grounded before you touch these
components. Use a grounding wrist strap and follow the instructions provided with the
wrist strap before you handle the components or open the appliance. If you do not have
a grounding wrist strap, make sure you are properly grounded before you touch any
electronic component.
You must perform an orderly shutdown of the appliance and turn the power off whenever you
remove the chassis tray assembly to service internal components.

Before You Start

To install or replace the encryption accelerator card in your appliance, you need the following:
Physical access to the appliance
A Check Point-approved encryption accelerator card
Access to the appliance through Network Voyager
A Phillips-head screwdriver
To install or replace a Check Point encryption accelerator card
1. Use Check Point Network Voyager or the CLI to perform an orderly shutdown of the IP150.
For information about how to access Network Voyager and the related reference materials,
see
Press the power switch, located on the back of the appliance, to turn off power to the
appliance.
2. Remove the power cord from the IP150 appliance, and remove the appliance from the rack.
3. Place the appliance right-side up and place it on a safe and protected work surface.
Check Point IP150 Security Platform Installation Guide
Installing or Replacing the Check Point Encryption Accelerator Card
"Using Check Point Network Voyager" on page 29.
47