Advertisement
Page 6
Step 7: To change or add a setpoint, place the <Run -
Program> switch on the rear of the IQ Transfer Logic
unit in the Program position (Figure 7). The red LED
next to Program on the front display will flash (Figure 6).
Figure 7 IQ Transfer Logic (Rear View)
Press the <Display Select> pushbutton until the Set
Points LED lights. Use the <Step> pushbutton to step
through the setpoints.
Use the <Increase> and <Decrease> pushbuttons to
change the setpoint.
When finished changing setpoints, return the <Run-
Program> switch to the Run position and wait. The dis-
play should display the word Program and the red LED
next to Program will go out. When the display goes
blank, the setpoints have been changed to their new
values.
QS4500TE0001
Effective 6/01
Advertisement
