Finelite HP-2 Recessed Installation Instructions page 2

HP-2 Recessed T-Bar Mitered Corner Installation Instructions
Step 5
Joiner/Ender
Diffuser
Remove diffuser from joiner/ender luminaire and set aside to prevent it from getting
dirty or damaged.
Step 8
Joiner/Ender
Double Diffuser
(pre-installed)
Starter
Remove back plate clips (provided) from back plates at corner joint.
Note: All power connections to be installed to
local/national codes by a Certified Electrician.
Step 6
Slide joiner/ender luminaire onto T-Bar.
Step 9
Back Plate Clip
Starter
Slowly swing down back plates. CAUTION: Do not twist back plate when swinging
down - it will come out of the support extrusion. Note that the screw shown is the
pivot point and the back plate can be slid a few inches either way for ease of
access to the driver space.
Finelite, Inc. • 30500 Whipple Road • Union City, CA 94587-1530 • (510) 441-1100 • Fax: (510) 441-1510 • www.finelite.com
Starter
Joiner/Ender
Joiner/Ender
Back Plate
Pivot Point
Step 7
Elbow Sleeves
Starter
Align elbow sleeves with channels in body. Slide joiner/ender onto starter.
IMPORTANT STEP
Step 10
Yoke Brackets
(provided)
Starter
IMPORTANT STEP: Secure joint with two yoke brackets (provided) using #10-32 x
5/8" screws (provided). CAUTION: When installed correctly these brackets will pull
luminaires together to make a tight joint. Do not over-tighten.
Joiner/Ender
Channels
#10-32 x 5/8"
Screws (provided)
Joiner/Ender
2