Eaton Cooper Power Series Installation Instructions Manual
Polymer-insulated cmu outdoor fuse open distribution
Hide thumbs
Also See for Cooper Power Series:
- Installation, operation and maintenance manual (189 pages) ,
- Installation, operation and maintenance instructions (128 pages) ,
- Installation and operation instruction manual (52 pages)
Related Manuals for Eaton Cooper Power Series
Summary of Contents for Eaton Cooper Power Series
- Page 1 COOPER POWER CMU Fuse SERIES Effective July 2019 MN132034EN Supersedes September 2018 UltraSIL® Polymer-Insulated CMU Outdoor Fuse Open Distribution Cutout Installation Instructions...
-
Page 2: Disclaimer Of Warranties And Limitation Of Liability
CONTENTS OF THIS DOCUMENT SHALL NOT BECOME PART OF OR MODIFY ANY CONTRACT BETWEEN THE PARTIES. In no event will Eaton be responsible to the purchaser or user in contract, in tort (including negligence), strict liability or other- wise for any special, indirect, incidental or consequential damage or loss whatsoever, including but not limited to damage or... -
Page 3: Safety Information
UltraSIL® Polymer-Insulated CMU Outdoor Fuse Open Distribution Cutout Contents SAFETY INFORMATION Safety information ................iv PRODUCT INFORMATION Introduction . -
Page 4: Hazard Statement Definitions
FOR LIFE FOR LIFE Eaton meets or exceeds all applicable industry standards relating to product safety in its Cooper Power™ series products. We actively promote safe practices in the use and maintenance of our products through our service literature, instructional training programs, and the continuous efforts of all Eaton employees involved in product design, manufacture, marketing, and service. -
Page 5: Product Information
Product information continuous current (fuse rating), basic insulation level (BIL) and fault interrupting rating. Introduction Eaton’s Cooper Power series UltraSIL Polymer insulated Mounting the cutout outdoor fuse holding cutout will accept CMU Fuses (See Securely attach the mounting bracket, if supplied Figure 1). - Page 6 UltraSIL® Polymer-Insulated CMU Outdoor Fuse Open Distribution Cutout Installation (fusing) in outdoor mountings While looking away from the cutout, quickly and firmly drive the fuse into the closed position. Attach the fuse end fittings (See Figure 3) as follows: The lower end fitting must be attached first. Slip the lower end fitting over the upper end of the fuse and slide it down until the locating slot seats on the locat- ing pin on the lower ferrule of the fuse.
-
Page 7: Operation
UltraSIL® Polymer-Insulated CMU Outdoor Fuse Open Distribution Cutout Operation When the fuse clears a fault, the dropout mechanism should allow it to drop open in the cutout. CAUTION Only qualified personnel should operate a cutout. Such personnel should always wear appropriate protective equipment such as rubber gloves, hard hats, safety glasses, etc., in accordance with established utility and safety practices. - Page 8 2300 Badger Drive Waukesha, WI 53188 Eaton.com/cooperpowerseries © 2019 Eaton Eaton is a registered trademark. All Rights Reserved For Eaton's Cooper Power series product information call 1-877-277-4636 or visit: Printed in USA All trademarks are property www.eaton.com/cooperpowerseries. MN132034EN Rev 01...