Advertisement
Available languages
Available languages
Installing your UPS system
4
4.1 Hardware installation guide
1. Placement & Storage conditions
Install the UPS in a protected area that is free of excessive dust and
has adequate air flow. Please place the UPS away from other units at
least 20 cm to avoid interference. Do NOT operate the UPS where the
temperature and humidity is outside the specific limits. (Please check the
specs for the limitations.)
2. Connect to utility and charging
Plug in the AC input cord to the wall outlet. For the best results, suggest
to charge the battery at least 6 hours before initial use. The unit charges
its battery while connecting to the utility.
3. Connect the loads
Plug in the loads to output receptacles on the front panel of the UPS.
Simply turn on the power switch of UPS unit, then devices connected to
the UPS will be protected by UPS unit.
CAUTION
Due to its high-power consumption, we do NOT recommend
connecting LASER PRINTERS or loudspeaker equipment
such as SUBWOOFERS to this type of UPS.
Do NOT plug any SURGE STRIPS into any of the outlets.
4. Connect communication cable
To allow for unattended UPS shutdown/start up and status monitoring,
connect the communication cable one end to the USB port and the other
to the communication port of your PC. With the monitoring software
installed, you can schedule UPS shutdown/start up and monitor UPS
status through PC.
8
5. Connect Modem/Phone /Network for surge protection
Connect a single modem/phone line into surge protected "IN" outlet
on the side panel of the UPS unit. Connect from "OUT" out let to the
computer with phone line cable.
6. Turn On/Off the unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit
by pressing again the power switch.
4.2 Software installation guide
Install software: For optimal computer system protection, install the UPS
monitoring software from
https://www.power-software-download.com/
viewpower.html
to fully manage the UPS.
Indicators
5
5.1 LED indicators (for Token 600 model)
Red
Yellow
LED
Alarm
Green (LED on)
Off
Sounding every
Yellow (LED flashing)
10 seconds
Sounding every
Yellow (LED flashing)
second
Green (LED off)
Off
Continuously
Red (LED on)
sounding
Green
UPS Status
The mains is normal and
UPS is operated normally.
Power failure occurs and
UPS is on battery mode.
Low battery
UPS is off.
UPS fault
9
Advertisement
