Configuring The Controller - Galcon AMC-6DC User Manual

Configuring the Controller

Configuring the Controller
The AMC controller is pre-configured at the factory for regular operation. The operation parameters of
each program can be changed according to the specific conditions at the actual installation site.
You change the program basic configuration or operation parameters in the Operator Mode or the
Technician Mode.
Operator Mode
In Operator mode you can change the following parameters:
Setting the time interval of the flushing program
1. In the Main screen, press the Forward key once. The following screen appears.
2. Press the Arrow key to move through the digits.
3. Move to the desired digit, the digit starts to blink for 10 seconds.
4. While the digit is blinking, press the Plus key to increase the value, or press the Minus key to
decrease the value.
5. Move to the next digit and set the value as described above.
6. Press the Forward key or the Backward key to move to the next or previous screen accordingly.
The new time interval is activated when exiting this screen.
Press the Manual and Pause keys together for a second in order to return to the Main screen.
29 AMC Flushing Controller User Guide