Irrigation Program; Accumulation; Programming The Irrigation Program - Galcon Galileo Manual

concurrently in one program apart from when it is a co-valve – see below). The date
when the valve last irrigated and the actual flow rate are also displayed.

Accumulation:

3.1.3
periodical water accumulation and up to 7 different fertilizer pumps (1 local and 6
fertilizer centers). The periodical accumulation also shows the accumulation start
date. All of the data can be edited i.e. can be zeroed or changed to a value other
than zero for monitoring purposes.
The valve settings are described in detail in the installation chapter. The solenoid
can be manually operated on the lower left hand side of the screen, this leads to the
valve being manually opened but if there is no water in the system nothing will occur.
When a valve is opened by a program the attached pipelines also open leading to the
activation of the entire system (as described in the preface). Manually operating the
valve's solenoid is generally used for testing purposes. Seeing that manual operation
prevents the valve from being automatically operated (opening or closing) a "valve
on manual mode" warning appears.

Irrigation Program

3.2
To open the irrigation program click on the blue number on the operation table or on any
irrigation program number in any part of the controller. The following screen appears:

3.2.1 Programming the irrigation program:

program the following data have to be entered:
3. Advanced Operation
(151) the right hand side of this screen shows daily and
This screen displays
programming parameters
from the irrigation
program and current
program operational
data.
(32) In order to program the irrigation
11