Related Manuals for Midea FP-65NRH060MMTL-B1
Summary of Contents for Midea FP-65NRH060MMTL-B1
- Page 1 RANGE HOOD FP-65NRH060MMTL-B1 Please read this User’s Manual carefully for proper use of Midea Range Hood.
-
Page 2: Recommendations And Suggestions
RECOMMENDATIONS AND SUGGESTIONS The instructions for Use apply to several versions of this appliance. Accordingly, you may nd descriptions of individual features that do not apply to your speci c appliance. INSTALLATION The manufacturer will not be held liable for any damages resulting from incorrect or improper installation. - Page 3 50-60Hz COMPONENTS Ref. Qty. Product Components Qty . Ref. Installation Components Check Valve Air Outlet Cap Screws 5mm x 49mm Plastic Wall Plugs...
- Page 4 DIMENSIONS unit：mm Min. Min. 650 mm 650 mm...
-
Page 5: Installation
INSTALLATION WALL DRILLING AND BRACKET FIXING Please read the instructions carefully. Unpack the canopy and check that all functions are working. Ensure that the voltage (V) and the frequency (Hz) indicated on the serial plate match the voltage and frequency at the installation site. Check that the area behind the installation surface to be drilled is clear of any electrical cables or pipes, etc. - Page 6 Inf ormation Sufficient air is needed for proper combustion and exhaustion of gases through the flue (chimney) of fuel burning equipment to prevent back drafting. Ductless fans must always be vented to the outdoors. When assessing the air pressure, the entire ventilation system in the house/apartment must be taken into account, e.g.
- Page 7 ATTENTION ...
-
Page 8: Operation
Information The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels. OPERATION OFF MOTOR SWITCH: Press on this switch to stop the motor operation. SPEED SWITCH: Press on this switch, the motor runs at LOW speed. - Page 9 LIGHTING LIGHT REPLACEMENT Switch off the extractor hood and isolate the extractor hood by pulling out the mains plug or switching off the fuse. Remove the grease filter. Remove the light by levering its fi�ng from the hood body (this may require pressure or force to be applied).
- Page 10 Inf ormation Remove the metallic filter from the range hood and wash it in a solution of water and neutral liquid detergent, leaving to soak. Rinse thoroughly with warm water and leave to dry. The metallic filter may alter in color after several washes. This should not be a cause for customer complaint.
-
Page 11: Troubleshooting
TROUBLE SHOOTING Fault Cause Solution The blades are blocked. The capacitor is damaged. Replace capacitor. Light on, but The motor is damaged. Replace motor. motor does not The internal wiring of motor is cut o / work Replace motor. disconnected. An unpleasant smell may be produced. - Page 12 A quality product of Customer Care Email: customercare@midea.com.ph Toll free: 1-800-10-863-5522 Landline: (02) 863-55-22 Viber/SMS: (0917) 863-5522 Monday - Sunday / 8:00am - 8:00pm...