Manitou F-E3 Series Operator's Manual page 88

3 - CONTROL AND SIGNAL LIGHTS PANEL
CONTROL INSTRUMENTS
A - I.C. ENGINE WATER TEMPERATURE
Temperature zone:
A1 - Blue zone (0° - 50°) Use the lift truck with moderation, wait for temperature to increase before normal operation.
A2 - Green zone (50° - 100°) Use lift truck normally
A3 - White/red zone (100° - 105°) Use lift truck with moderation, monitor the temperature.
A4 - Red zone (105° - 120°) Stop the lift truck, look for the cause of overheating.
NOTE: Red indicator
B - HOUR METER AND REV COUNTER
C - FUEL LEVEL
Red zone C1 indicates that you are using the reserve supply and that time of use is limited.
D - CLOCK
SIGNAL LIGHTS
A permanently lit or flashing warning lamp, with the engine running, is the sign of an operating fault. The lighting of some lamps may be accompanied
by an audible signal. Do not ignore this warning, consult your dealer without delay.
If one of the warning lamps comes on while the lift truck is in motion, stop the lift truck under the safest possible conditions.
When activating the electrical system of the lift truck, all the red and orange lamps and the panel's buzzer must light to indicate
their good working order. If one of the red lamps or the buzzer does not function, carry out the necessary repairs.
STOP
NOTE:
ORANGE I.C. ENGINE PREHEATING INDICATOR LIGHT
Preheating is necessary. When the lift truck is switched on, the lamp comes on for 2 seconds and off as soon as preheating
is ended. Start the lift truck's I.C. engine.
ORANGE I.C. ENGINE WARNING INDICATOR LIGHT
If the lamp comes on or flashes while the lift truck is in operation, a diagnostic fault has been detected. The lift truck will
operate in reduced mode. Consult your dealer without delay.
RED I.C. ENGINE STOPPED INDICATOR LIGHT
STOP If the lamp comes on or flashes, when the lift truck is running, stop the I.C. engine immediately and consult your dealer.
RED STEERING SYSTEM OIL PRESSURE WARNING INDICATOR LIGHT
If the lamp comes on when the lift truck is running, stop the I.C. engine immediately and look for the cause (possible
leak, etc.).
NOTE: The indicator lights
C1
D
12
9 3
6
light comes on between zone A3 and A4.
only for: MLT ... -120 ...
STOP
go off after engine preheating.
B
15
C
10 20
RPM x 100
5 25
0 30
2-56
A1 A2 A3 A4
A