Manitou F-E3 Series Operator's Manual page 152

C4 - ANGLE GEAR BOX LEVEL
Park the lift truck on level ground with the jib raised and the I.C. engine stopped.
- Remove level plug 1 (fig. C4).
- Wipe the dipstick and check the correct level between the MIN and MAX marks.
- If necessary, add oil (see: 3 - MAINTENANCE: E5 - ANGLE GEAR BOX OIL).
C5 - PARKING BRAKE
Place the lift truck on level ground with the rated load in the transport position.
- Check braking by locking the parking brake in position A (fig. C5).
- Pull on the lift truck rear towing pin with a minimum force of 3500 daN. The wheels of the
lift truck must not rotate.
- Carry out adjustments if necessary.
- Progressively tighten the end piece of the lever 1 (fig. C5) and recheck the braking.
- Repeat the operation until the correct braking adjustment is obtained.
C6 - CAB VENTILATION FILTER (OPTION AIR CONDITIONING)
- Unscrew thumbscrew 1 (fig. C6/1) and remove protective guard back 2 (fig. C6/1).
- Lift out cabin ventilation filter 3 (fig. C6/2) and replace it with a new one
(see: 3 - MAINTENANCE: FILTERS AND BELTS).
- Refit the protective casing.
C7 - HEATING BLOCK NON-RETURN VALVE
- Since non-return valve 1 (fig. C7) is located under the cab, it is possible for it to become
obstructed with spattered mud for example. Clean if necessary.
CHECK
CHECK - ADJUST
CHANGE
CLEAN
3-28
C4
1
C5
A
1
B
C6/1
2
1
C6/2
3
C7
1