Appendix A Installation Tools And Supplies - GE Kelman TRANSFIX 1.6 Installation Manual

The tools and supplies for a product installation are listed below. If GE performs the
installation, the GE installation engineer will provide these items:
A.1 GE-supplied Items
Qty Description
2 / in. Combination wrench (must be imperial
9
16
1 30 cm (12 in.) Adjustable wrench
1 35 – 40 cm (14 in.) Pipe wrench
1 / flat blade screwdriver
1
8
1 ¼ in. flat blade screwdriver
1 #2 Phillips screwdriver
1 ¼ in. Tubing bender
1 ¼ in. Tubing cutter
1 Non-metallic tape measure
1 Level capable of indicating plumb and level within 5 degrees
1 Permanent marker (fine tip)
1 22 – 14 Gauge wire cutter/stripper
1 Small diagonal cutting pliers
1 Quality vacuum pump with approximately 3 ft of clear ¼ in. tubing fitted with a ¼ in.
compression fitting at the end of the tubing
1 roll 12 mm (½ in.) width PTFE pipe-sealing tape or PTFE pipe compound
25 30 cm (12 in.) Nylon UV-resistant cable ties
1 bag ¼ in. tubing P clamps
1 Laptop computer for commissioning the product and running the TRANSCOM software for
downloading and interpreting the results of the gas analysis. Minimum specification:
Windows® 2000 or Windows® XP operating system, PII 400 MHz processor, 128 MB of RAM
and 1.2 GB hard drive space, 28.8 Kbps modem or faster and USB 1.1 or faster.
A.2 Customer-supplied Items
The following tools and supplies are needed on site to secure the mounting stand (if
used), tighten the 2 in. pipe fittings (if used) and complete the installation. GE is unable to
bring the following items due to size and weight restrictions, so the customer should
provide them.
Qty Description
1 12 mm (½ in.) capacity hammer drill with 9.5 mm (
1 36 in. pipe wrench if large fittings are used to provide oil to the product
1 Scaffolding, lift or approved platform to obtain access to valves (if needed)
1 Suitable vessel to collect at least 4 litres of waste oil during the commissioning process
1 Absorbent cloths
12 M8 threaded fasteners with a recommended minimum length of 80 mm for the concrete pad
TRANSFIX Installation Manual
Appendix A
34
Installation Tools and Supplies
/ in.)
9
16
/ in.) masonry bit
3
8
TRANSFIXFAMILYIM Rev 3 18-Jan-16