Year Guarantee - Maxview Precision Waterways MXL024/55 Installation & Operating Instructions Manual

Table of Contents

Advertisement

Safety Warnings
 Designed for stationary use only. Remove from mount when boat is moving.
 Take care when adjusting systems, to avoid finger/s being trapped.
 Always route cables carefully to avoid tripping over causing injury.
 Always switch power off at the mains before starting any electrical work.
Care & Maintenance
The Precision has been designed to be maintenance and trouble free.
For optimum signal strength, keep the antenna clean from dirt, bugs and other debris.
1. Always handle the Precision kit with care. Do not drop the antenna.
2. Never power wash your Precision Kit. Keep the system clean from dirt, bugs, and other
debris by hand washing with mild soap and water.
!
DO NOT USE SOLVENTS TO CLEAN YOUR PRECISION SYSTEM.

2 Year Guarantee

Every new Precision System is thoroughly inspected and tested before leaving the factory and is covered by our
two years guarantee from the date of original purchase.
Maxview is responsible for the cost of a replacement part if the original part is determined to be defective
under the terms of guarantee. The customer is responsible for the cost of replacement parts after two years.
Should any trouble develop during the guarantee period please contact Maxview before the expiry date.
If you do experience a problem with the product contact Maxview Customer Services on
+44 (0)1553 811000 or email support@maxview.co.uk
Please make sure you have the following ready when you call:
• Model number • Serial number • Date of purchase • Clear and concise details of the fault
The guarantee does not apply where:
• The product has been abused, misused, improperly installed or improperly maintained.
• The product has been installed without the use of Maxview mounting brackets
• Repairs have been made or attempted by a third party other then Maxview
• Repairs are required due to normal wear and tear
• Modifications have been made to the product
• Damaged caused by abrasive cleaning or power washing
• Circumstances beyond the control of Maxview that have caused the product to no longer operate correctly
• Customer is not the original owner or cannot provide proof of purchase
In no event shall Maxview be liable for any indirect, incidental, or consequential damages from the sale or use
of the product. This disclaimer applies both during and after the term of the guarantee. This does not affect your
statutory rights
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Precision waterways mxl024/55twin

Table of Contents