Table of Contents
Advertisement
Removing The Nylon
Mount From The Base
If you find the mount obtrusive, then Nylon part has
been designed for easy removal from the metal plate.
Remove the 3 Screws* holding the two parts
together as highlighted in the image above.
This will free the Nylon mount from the plate.
* Please do not over tighten the screws as this
may result in damage to the thread within the
metal plate
Setting Up the Precision Waterways
1
Offer dish unit onto mount.
3
S
N
Use compass to point dish South-East.
1
2
Pull down LNB arm from magnetic lock.
4
Single Port
Twin Port
Connect the 10m Flexible Cable to the cable
connection port. See page 14 for receiver end
connections.
Sat Finder is wired to the single port.
!
7
Advertisement
Table of Contents
