System Options
1. McIAS AppSOFT Software Module
2. Ethernet Transceiver Assembly
3. DB15 to BNC Conversion Cable (McTi-30 connection to telco)
4. Digital Connector Block
5. Analog Connector Block
6. Mounting brackets to widen unit to:
19"
21"
23"
25"
26"
Mounting brackets are packaged as a kit; each kit contains two brackets and
mounting hardware.
2.3
Visual Inspection
After carefully unpacking McIAS 1610, perform the following visual inspections:
*
Examine the exterior of the McIAS 1610 unit for evidence of damage during
shipping. Report any signs of damage no matter how insignificant to the
appropriate authorities within your company for possible claim against the
carrier.
*
If boards have been dislodged or damage is apparent, individually remove and
examine each printed circuit board contained within the McIAS 1610 card file.
If defects are found (i.e. broken components, cracked connectors, etc.) attach
a tag noting the defect(s) and return the printed circuit board(s) to Cognitronics
Corporation. See Section 4.0 in Volume II for return instructions.
If no defects are found, re-install the board.
11