Checking The Decompression System; Installing The Camshafts - Yamaha WR250F 2017 Owner's Service Manual

CHECKING THE DECOMPRESSION SYS-
EAS2GBB242
TEM
1. Check:
• Decompression system
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Check that the decompressor cam "1"
moves smoothly.
b. Check that the decompressor lever pin "2"
projects from the camshaft.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲

INSTALLING THE CAMSHAFTS

EAS2GBB243
1. Install:
• Exhaust camshaft "1"
• Intake camshaft "2"
2
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Turn the crankshaft counterclockwise with a
wrench.
TIP
• Apply molybdenum disulfide oil to the cam-
shafts.
• Apply the engine oil on the decompression
system.
b. Align the top dead center (TDC) mark "a" on
the rotor with the alignment mark "b" on the
crankcase cover.
c. Fit the timing chain "3" onto both camshaft
sprockets and install the camshafts on the
cylinder head.
TIP
Make sure that the alignment mark "c" on the
exhaust camshaft sprocket and the alignment
mark "d" on the intake camshaft sprocket are
aligned with the edge of the cylinder head.
d
1
ECA33DD029
NOTICE
Do not turn the crankshaft during the cam-
shaft installation. Damage or improper
valve timing will result.
d. Install the clips, the camshaft caps and the
bolts (camshaft cap).
TIP
• Before installing the clips, cover the cylinder
head with a clean cloth to prevent the clips
from coming off into the cylinder head cavity.
• Apply the engine oil to the threads and con-
tact surfaces.
• Tighten the bolts to the specified torque in two
or three steps in the proper tightening se-
quence as shown.
6-17
CAMSHAFT
3
Bolt (camshaft cap)
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
b
a
c