3
Fig.3: Ensure that the rubber double-lobe cam is facing the right direction.
Fig.6: Slide the battery down into the frame anchor.
Fig.5: Rotate the battery up into the down tube, then insert the battery axle. Torque the axle to 88.5 in-lbf (10 Nm).
WARNING! Place the charger on a stable, level surface unaffected by heat. You should charge the
battery in a dry, well ventilated area and make sure the charger is uncovered during the charging
process. Ensure that the battery and charger are not exposed to any flammable or dangerous
substances. Plug the charger's plug into an outlet (100 - 240V), using the appropriate plug for
the country's standards, then connect the charging plug with the charging socket on the battery.
Specialized recommends charging the battery in an area with a smoke detector.
4
CHARGING PLUG
CHARGING SOCKET
Fig.4: Locate the charging socket on the non-drive-side of the battery, near the bottom bracket.
WARNING! Place the charger and the battery on a stable, level surface unaffected by heat. You should
charge the battery in a dry, well ventilated area and make sure the battery and charger are uncovered
during the charging process. Ensure that the battery and charger are not exposed to any flammable or
dangerous substances. Plug the charger's plug into an outlet (100 - 240V), using the appropriate plug
for the country's standards, then connect the charging plug with the charging socket on the battery.
Specialized recommends charging the battery in an area with a smoke detector.
11
INSTALLING THE BATTERY
CHARGING THE BATTERY IN THE FRAME
CHARGING THE BATTERY OUT OF THE FRAME
WIRING HARNESS
CAUTION: ALWAYS
TURN OFF THE
BATTERY BEFORE
PLUGGING OR
UNPLUGGING!