It is possible to control this unit and other YAMAHA A/V components using the remote control supplied with this unit.
It is also possible to control components from other manufacturers (or some YAMAHA components) by setting the
proper manufacturer code (a signal assigned to each manufacturer and component).
• For the notes on batteries, operating distance and names and functions of the remote control, refer to each description in this manual.
Select the component (position) to be controlled by the remote control. For example, if the CD position is selected, the
remote control is set in the CD operation mode, allowing the CD player to be controlled. When turning the selector dial,
the position changes as follows:
You can perform the basic operations
of this unit.
The code for a YAMAHA CD
player is factory-set.
A cable TV or satellite tuner can be controlled.
A VCR can be controlled.
A TV can be controlled.
• The general operational buttons on the remote control differ depending on the position of the selector dial. See the following pages
• When shipped from the factory, the YAMAHA manufacturer codes listed on page 46 are set for each dial position. If unable to
operate your YAMAHA A/V component, please try using another YAMAHA code.
REMOTE CONTROL FEATURES
The code for a YAMAHA MD recoder is factory-
set. Be sure to set the proper code when
operating a CD recorder or tape deck.
DVD/LD & DVD MENU
An LD player can be controlled in
the DVD/LD position. A DVD player
can be controlled in the DVD/LD
and DVD MENU positions. The
code for a YAMAHA DVD player is
This unit can be controlled and DSP
programs can be selected directly.