Yamaha DSP-AX620 Owner's Manual page 29

I Notes on playing a source
encoded with a DTS signal
• If the digital output data of the player has been
processed in any way, you may not be able to
perform DTS decoding even if you make a digital
connection between this unit and the player.
• If you play a source encoded with a DTS signal and
set the input mode to ANALOG, this unit reproduces
the noise of an unprocessed DTS signal. When you
want to play a DTS source, be sure to connect the
source to a digital input jack and set the input mode
to AUTO or DTS.
• If you switch the input mode to ANALOG while
playing a source encoded with a DTS signal, this unit
reproduces no sound.
• The following phenomena may occur if the input
mode is set to AUTO when playing back source
encoded with a DTS signal.
– If you continue to play a source encoded with a DTS
signal, this unit automatically switches to the "DTS-
decoding" mode to prevent noise from being
generated during subsequent operation. (The "t"
indicator lights up on the front panel display.) The
"t" indicator may flash immediately after
playback of a source encoded with a DTS signal has
finished. Only a source encoded with a DTS signal
can be played back while this indicator is flashing.
(The indicator will flash for less than a minute.) If
you want to play a normal PCM source soon, set the
input mode back to AUTO.
– The "t" indicator may flash when a search or
skip operation is performed. If this status continues
for a certain length of time, the unit will
automatically switch from the "DTS-decoding"
mode to PCM digital signal input mode and the
"t" indicator will go out.
BASIC PLAYBACK
27