Adjusting The Level Of The Effect Speakers - Yamaha DSP-AX3200 Owner's Manual

ADJUSTING THE LEVEL OF THE EFFECT SPEAKERS

You can adjust the output level of each effect speaker
(center, left and right rear, rear center and subwoofer)
while listening to a music source.
Adjustment should be made with the remote control.
A/B/C/D/E
TV INPUT
TV VOL
TV MUTE
2
ON SCREEN LEVEL
SLEEP TEST
3
1
Set PARAMETER/SET
MENU to PARAMETER.
2
Press LEVEL repeatedly to select the
speaker(s) you want to adjust.
Each time you press LEVEL, the selected speaker
changes and appears on the front panel display as
follows: center, right rear, rear center, left rear and
subwoofer.
LEVEL
y
• Once you press LEVEL, you can also select the speaker(s) to
be adjusted by pressing n/k.
LEVEL
PRESET
MUTE
CH VOLUME
STEREO
DISC EFFECT
1
PARAMETER
SET MENU
PARAMETER
SET MENU
Center speaker output level
Right rear speaker output
level
Rear center speaker output
level
Left rear speaker output
level
Subwoofer output level
3
Press –/+ to adjust the speaker output level.
• The control range for the center, left and right rear
or rear center speakers is from +10 dB to –10 dB.
• The control range for the subwoofer is from 0 dB
to –20 dB.
y
• When PARAMETER/SET MENU is set to SET MENU, you
cannot adjust the output level by using LEVEL. However, each
time you press LEVEL, the current level of each speaker
appears on the front panel display and you can check the
speaker level.
Notes
• When the speaker output modes for "1A CENTER SP" and
"1C REAR L/R SP" are set to NONE, and "1E LFE/BASS
OUT" to MAIN, the output level of those speakers cannot be
adjusted because there is no sound coming from these speakers.
• When you adjust the output level with LEVEL, the settings you
made with the test tone will be changed.
• It is recommended to adjust the speakers (except for a
subwoofer) by following the steps described in Using the Test
Tone on pages 22 and 23.
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is in the standby
mode. However if the power cord is disconnected from
the AC outlet, or the power supply is cut for more than
one week, the stored data will be lost. If so, set the
output level again.
61