Adjusting The Speaker Output Levels; Before You Begin; Using The Test Tone (Test Dolby Sur.) - Yamaha DSP-AX3200 Owner's Manual

ADJUSTING THE SPEAKER OUTPUT LEVELS

This section explains how to adjust the speaker output
levels by using the test tone generator. When this
adjustment is made, the output level heard at the listening
position will be the same from each speaker. This is
important for the best performance of the digital sound
field processor, and various decoders (Dolby Digital,
Dolby Pro Logic, Dolby Pro Logic , DTS, DTS ES, and
DTS Neo: 6).
Note
• Since this unit cannot enter the test mode while headphones are
connected to this unit, be sure to unplug the headphones from
the PHONES jack when using the test tone.

Before You Begin

2
NATURAL SOUND AV RECEIVER
STANDBY
/ON
SPEAKERS
A B
DVD
D-TV/LD
SILENT
CBL/SAT
VCR1
BASS PROCESSOR
EXTENSION DIRECT VCR2
/DVR
PHONES
V-AUX
– + – +
BASS TREBLE
3 3
A/B/C/D/E
TV INPUT
TV VOL
TV MUTE
ON SCREEN LEVEL
SLEEP TEST
1
Turn on the video monitor connected to this
unit.
2
Press SPEAKERS A or B
to select the main
speakers to be used.
If you are using two sets of the
main speakers, press both A
and B.
3
Set the BASS and TREBLE controls on the
front panel to the center position and turn off
BASS EXTENSION and PROCESSOR
DIRECT by pressing the buttons.
"BASS EXT. OFF" and "P. DIRECT OFF" appear
on the front panel display.
– + – +
BASS
TREBLE
22
INPUT VOLUME
INPUT MODE
D I G I T A L
NEXT – SET MENU +
SOURCE
MD/TAPE
CD-R
TUNER
CD S VIDEO VIDEO L AUDIO R OPTICAL
6CH
PHONO STEREO PROGRAM INPUT
EFFECT
REC OUT VIDEO AUX
PRESET
MUTE
VOLUME
CH
STEREO
DISC EFFECT
4
PARAMETER
SET MENU
SPEAKERS
A B
BASS PROCESSOR
EXTENSION DIRECT
Set to OFF.
4
Set PARAMETER/SET
MENU on the remote
control to PARAMETER.
Using the Test Tone (TEST DOLBY
SUR.)
Use the test tone to balance the output levels of the 6
speakers required for a surround sound system. The
adjustment of each speaker output level should be made at
your listening position with the remote control.
NATURAL SOUND AV RECEIVER
STANDBY
/ON
SPEAKERS
A B
SOURCE
DVD
D-TV/LD
SILENT
CBL/SAT
VCR1
BASS PROCESSOR
EXTENSION DIRECT VCR2
/DVR
PHONES
V-AUX
– + – +
BASS TREBLE
REC OUT
TV VOL
ON SCREEN
SLEEP
1, 4
1
Press TEST to output the
test tone.
2
Adjust the volume so you can hear the test
tone.
The test tone is heard from the left main speaker,
center speaker, right main speaker, right rear speaker,
rear center speaker and left rear speaker in order. The
tone is produced for 2.5 seconds each time.
VOLUME
Front panel
PARAMETER
SET MENU
2
INPUT VOLUME
INPUT MODE
D I G I T A L
NEXT – SET MENU +
MD/TAPE
CD-R
TUNER
CD S VIDEO VIDEO L AUDIO R OPTICAL
6CH
PHONO STEREO PROGRAM INPUT
EFFECT
VIDEO AUX
PRESET
A/B/C/D/E
2
TV INPUT
MUTE
CH VOLUME
STEREO
TV MUTE
DISC EFFECT
PARAMETER
LEVEL
SET MENU
TEST
3
TEST
or
VOLUME
Remote control