Technical Data
Maximum fluid working pressure . . . . . . . . . . . . . . . . . . . 120 psi (0.8 MPa, 8 bar)
Air pressure operating range . . . . . . . . . . . . . . . . . . . . . . 20-120 psi (0.14-0.8 MPa, 1.4-8 bar)
Maximum air consumption . . . . . . . . . . . . . . . . . . . . . . . . 175 scfm
Air consumption at 70 psi/60 gpm . . . . . . . . . . . . . . . . . . 60 scfm (see chart)
Maximum free-flow delivery . . . . . . . . . . . . . . . . . . . . . . . 150 gpm ( 570 l/min)
Maximum pump speed . . . . . . . . . . . . . . . . . . . . . . . . . . . 145 cpm
* Gallons (Liters) per cycle . . . . . . . . . . . . . . . . . . . . . . . . 1.03 (3.90)
Maximum suction lift . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Flapper 10 ft (3.5 m) wet
Maximum size pumpable solids . . . . . . . . . . . . . . . . . . . .
** Maximum Noise Level at 100 psi, full flow . . . . . . . . . . 89 dBa
** Sound Power Level . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100 dBa
** Noise Level at 70 psi and 50 cpm . . . . . . . . . . . . . . . . . 78 dBa
Maximum fluid operating temperature is based on the fol-
lowing maximum diaphragm, ball, and seat temperature
ratings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Air inlet size . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5" npt(f)
Wetted parts
***All fluid contact materials are FDA-compliant and meet the United States Code of Federal Regulations (CFR)
Title 21, Section 177.
All fluid contact materials are FDA-compliant.
Wetted materials on all models. . . . . . . . . . . . . . . . . . . . .
Wetted material depending on model . . . . . . . . . . . . . . . .
Note: Santoprene® may be used only with non-fatty, non-oily foods or alcohols up to 15%.
Non-wetted external parts. . . . . . . . . . . . . . . . . . . . . . . . .
Weight
Models with stainless steel center sections . . . . . . . . . . . 145 lb. (66 kg)
Viton® is a registered trademarks of the
Santoprene® is a registered trademarks of the Monsanto Co.
Loctite® is a registered trademark of the Loctite Corporation.
*Displacement per cycle may vary based on suction condition, discharge head, air pressure, and fluid type.
**Noise levels measured with the pump mounted on the floor, using rubber feet. Sound power measured per
ISO Standard 9614-1.
***The pump user must verify that the construction materials meet their specific application requirements.
310622C
Ball 18 ft (5.5 m) wet
Flapper 2.5 in. (63.5 mm)
Ball 1.0 in. (25.4 mm)
PTFE 220°F (104.4°C)
Santoprene® 180°F (82.2°C)
Buna-N 180°F (82.2°C)
Viton® 250°F (121.1°C)
316 SST, 3A Approved Buna-N (Nitrile)
PTFE
PTFE
316 SST,
3A Approved Buna-N
300 series stainless steel, polyester (labels), Santoprene®
(gasket), LDPE foam (gasket)
Co.
, Santoprene®, Buna-N (Nitrile), Viton®,
Technical Data
35