ADJ VIZI BEAM 12RX User Manual page 19

S Y S T E M M E N U
MAIN MENU OPTIONS / VALUES (Default Settings in BOLD)
DMX Address
DMX Channel Mode 13ch, 17ch
DMX Settings
No DMX Status
Status Settings
Reset Motors
Personality
Display
Service
ADJ VIZI BEAM 12RX - SYSTEM MENU
Default setting shown in bold
Supports Software Versions: 1.2
001 - 512
Hold Last
Blackout
Manual
Pan Invert ON / OFF
Tilt Invert ON / OFF
P./T. Feedback ON / OFF
P./T. Feedback Speed 1, Speed 2
Hibernation OFF, 01M~99M, 15M
Reset All Motors YES / NO
Pan/Tilt Reset YES / NO
Color Reset YES / NO
Gobo Reset YES / NO
Frost Reset YES / NO
Prism Reset YES / NO
Intensity 1-10
Display Invert YES / NO
Screen Saver
OFF - 10 minutes
Delay
Pan 128-127
Tilt 128-127
Effect Adjust
Color 000-255
(Calibration)
...
Shutter 000-255
USB Port Power ON / OFF
Update Software YES / NO
Factory Restore YES / NO
Shall be used to set the units starting DMX address
channel. Depending on set DMX mode, unit shall
not allow to be addressed any higher that will not
allow for all channels to be accessed from the
console.
Shall be used to set the units desired DMX mode.
Shall be used to set the units behavior when DMX
signal is not present. Hold shall be the default
setting and unit shall hold all last channel values
received from the console when signal is lost.
Blackout option shall take all channels to zero (0)
when signal is lost.
Manual Settings option shall take all channels to
the last set Manual channel settings when signal is
lost.
When DMX signal is not present for the set time,
the unit shall go into standby mode after the set
time. When set to OFF, unit shall never go into
hibernation mode. The unit should have 01M to
99M options... so 01M, 02M, 03M... 99M
(M=Minutes). 15M should be default.
Effects adjustments (Passcode = 050). Do not
adjust effect settings when performing a factory
reset at the same time.
Reset to factory default
1 9
DESCRIPTION