Cassette Tape Operation - Yamaha CC-5 Owner's Manual

CASSETTE TAPE OPERATION

2 3
(a)
1
6
PROG CLEAR
REPEAT
b
a
HALL JAZZ CLUB
3
POWER
(a)
Dolby B and C Type Noise Reduction
With cassette tapes, the most noticeable form of noise is high
frequency hiss. To reduce this hiss noise, this unit has been
equipped with a newly developed Dolby C noise reduction
system in addition to its conventional Dolby B NR. Either type
of noise reduction may be selected with the switch provided.
Dolby B NR has a noise reduction effect of about 10 dB in
the high frequency range. The corresponding figure with
Dolby C NR is about 20 dB, but this is over the entire range
where the human ear is most sensitive to noise (2 kHz to 8
kHz). Also, Dolby C NR has the same noise reduction effect
at both high and low signal levels. In addition, Dolby C NR
improves the tape's MOL (Maximum Output Level).
Dolby noise reduction is a 2 part process that acts both on
recording and playback; be sure that the noise reduction
button is set to the same position on record and play.
* Noise in the source material cannot be reduced with the
Dolby NR system.
1
3
(b)
2 3 4 5
7 8 9 0
+
CALL TIME 10
3
(b)
CD
BAND TUNER
ROCK CNCT OFF TAPE
+
AUX - VOLUME
DAT
Continuous playback
1
Load the tapes into the tape "a" and tape "b" cassette
compartments.
2
Set the REVERSE MODE switch as desired.
The REVERSE MODE switch can be operated before or
during playback, and changes tape playback as follows:
<Tape "a">
<Tape "a">
3
Press the play
play button for side B.
Dolby and the double D mark are trademarks of Dolby
Laboratories Licensing Corp. Dolby noise reduction
system manufactured under license from Dolby
Laboratories Licensing Corp.
E-24
Tape "a" Side A B Tape "a" Side A
Tape "b" Side A Tape "b" Side A
B B
Continuous play
Tape "a" Side B Tape "a" Side B
Tape "b" Side A B Tape "b" Side A
Tape "a" Side A
Continuous play
button to listen to side A, or the
B
B