How To Use The Built-In Timer - Yamaha CC-5 Owner's Manual

HOW TO USE THE BUILT-IN TIMER

6 5
3
CLEAR
2
4
1
1
2
1
3
Before setting the timer clock, make sure that the current
time is correct.
Timer operation
To listen to the tuner
1
Select the TUNER position.
2
Tune to the desired station. (Refer to the "TUNER
OPERATION" on page 19.)
3
Press the DISPLAY button.
4
While the "TIMER" indicator is flashing, and while pressing
the TIME ADJUST button, press the HOUR and MINUTE
buttons to set the desired time.
5
Release the TIME ADJUST button.
* When the start time of the timer is set by mistake,
press the CLEAR button and repeat step 4.
6
Press the TIMER button.
* "TIMER" appears on the display.
This sets the timer to the stand-by condition.
* The tuner turns on automatically at the desired time.
To play a compact disc
1
Select the CD position.
2
Load the disc.
3
Perform steps 3 – 6 of the "To listen to the tuner" section.
* CD playback starts automatically at the desired time.
To playback a cassette tape
1
Select the TAPE position.
2
Load a recorded cassette tape into the tape "a" or tape "b"
cassette compartment.
* If tapes are loaded in both the compartments, tape "b"
will be played back by the timer play.
3
Set the TIMER switch to the PLAY position.
4
Perform steps 3 – 6 of the "To listen to the tuner" section.
* Tape playback starts automatically at the desired time.
(Playback of the side which corresponds to the play
button which illuminated just before the timer setting
was completed will commence.)
E-31