Advertisement
Function Introduction
Power Supply/ Balance Switch: For using power supply as balance button at first
please press the power supply once lightly and the signal strength LED will flash 2 times
while the vibrator will vibrate 2 times for a short time. Then the white illumination LED
will light which means the pinpointer is connected and completed adjust balance and you
enter the using state.
Please press the power supply switch for about 3 seconds. The white illumination LED will
extinguish and the power supply will turn off.
The power switch also can use as the balance button. Whenever you press the power
supply once lightly , it will be balanced automatically.
LED signal strength indication and vibration alarm: When metals are detected, the
vibration motor will begin to vibrate while the red signal strengthen LED is light .With the
probe's movement it approaches more nearby to metal targets the vibration frequency
will be higher .The signal strength LED will light in the order of red, green, blue and white
.When it lights until white the motor vibration frequency will be highest.
Illumination LED-- After the pinpointer turned on the white illumination LED will light
which means the detector is in the work and also can use as a flashlight.
Search Probe: The built in antenna uses for transmitting and receiving signals. 360
°degrees of 2-3 cm in the head is the higher sensitivity detection section.
Low voltage alarm: When the battery is low LED will flash continuously. It means it is
time to change the 9V battery.
Battery and the battery cover: Please rotate the battery cover counterclockwise
to open it and please rotate clockwise to fasten it. Please pay attention to use
of the 9V alkaline battery. The lifetime of the alkaline battery is about 20 hours.
When changing batteries, ensure the battery is a tight connection and the O-type
rubber ring is placed well and tighten the battery cover to prevent a water leak.
Leather cover and wristband—Please insert the pinpointer into the leather cover for use
easily and put the wristband on the battery cover.
Automatic Shutdown: f you doesn't operate for 5 minutes it will shut down automatically.
15
Advertisement
