Setup Multiple Machines In A Sequence - MAGIC FX PSYCO2JET User And Installation Manual

3.5

SETUP MULTIPLE MACHINES IN A SEQUENCE

1. Connect a power link cable to the power output.
2. Connect the other end to the power input of the next machine.
POWER IN POWER OUT
3. Connect a DMX cable to the DMX output.
4. Connect the other end to the DMX input of the next machine.
DMX IN DMX OUT
5. Use the display and buttons or a RDM controller to set the machine into RAW
or PRESET mode and to assign DMX addresses, see chapter 1.
6. Repeat steps 1 – 5 for each subsequent machine.
CAUTION
PowerCon TRUE1 male
5-pole male
Always plug in a DMX Terminator into the DMX output of the final
unit in the control sequence. Using a DMX Terminator improves
signal reliability.
MAGICFX
PowerCon TRUE1 female
POWER
5-pole female
DMX
PSYCO2JET — User and Installation Manual
®
POWER IN POWER OUT
DMX IN DMX OUT
27