LIABILITY MAGIC FX accepts no liability for claims from third parties arising from unauthorised use, use other than that stated in this manual, and use other than in accordance with the General Conditions registered at the Chamber of Commerce.
General safety rules Indoor use Noise level Safety symbols 2.6 Precautions for operation Let’s shoot! (De)attach the shoulder strap Connect CO (Re)load with textiles 3.4 (Re)load with confetti and/or streamers Shoot 3.6 Clean up Troubleshooting Maintenance Correct disposal Declaration of Conformity MAGICFX CO2LAUNCHER — User and Installation Manual ®...
FOREWORD Congratulations! You have bought a great new product from MAGIC FX. This manual contains all information required for the intended use of the equipment. Deviation from the described intended use can result in a hazardous situation and/or property damage.
MEET THE MAGICFX CO2LAUNCHER! ® The MAGICFX CO2LAUNCHER is a handheld gun-shaped device for safe shooting of ® , confetti, streamers or T-shirts into the air. Before operation the MAGICFX CO2LAUNCHER needs to be connected to a CO ® cylinder. When the user squeezes the handle, the CO is released from the barrel.
Environment Minimum Temperature -15 °C 5 °F Maximum Temperature 100 °C 212 °F Humidity (Relative) 20% to 90% (non condensing) IEC 60529 (IP) Rating IP12 Controlling Control Options Manual Technical data 6 MAGICFX CO2LAUNCHER — User and Installation Manual ®...
Please contact MAGIC FX for additional possibilities. PROJECTILES The MAGICFX CO2LAUNCHER can shoot confetti, streamers and T-shirts. The ® maximum output distance per shot depends on the speed the trigger is pulled and the type of projectile. Check the following table.
Always consult your CO supplier for regulations and instructions on safe installation and use. MAGIC FX is not liable for unsafe situations, accidents and damage that are the result of incorrect working with CO gas and CO cylinders.
INDOOR USE The MAGICFX CO2LAUNCHER is designed for outdoor use and use in well-ventilated ® indoor spaces. When used indoors, make sure you take the necessary preparations. These preparations could include, but are not limited to: • Consulting your CO supplier.
Make sure all safety symbols are correctly in place, see section 2.5. During operation electrostatic discharge can occur when the NOTICE machine is touched. Prevent the discomfort of a possible static shock by wearing gloves. 10 MAGICFX CO2LAUNCHER — User and Installation Manual ®...
Deattach the shoulder strap by removing the shoulder strap out of the shoulder strap mounting holes. CONNECT CO Make sure that the safety catch is in locking position. MAGICFX CO2LAUNCHER — User and Installation Manual ®...
Page 12
CO quick connector. Connect the CO₂ Bottle to Hose Connector to a CO cylinder. Connect the CO hose to the CO₂ Bottle to Hose Connector on the CO cylinder. MAGICFX CO2LAUNCHER — User and Installation Manual ®...
Open the CO cylinder. (RE)LOAD WITH TEXTILES Filling the tube with products than otherwise specified, can cause WARNING serious injury or death. Push the unlock button to open the launcher. MAGICFX CO2LAUNCHER — User and Installation Manual ®...
Page 14
Lay the T-shirt flat. Start rolling the T-shirt from the neck into a light roll. When done, pull the opposite side to ensure the tightness of the roll. Fixate the roll by using rubber bands. MAGICFX CO2LAUNCHER — User and Installation Manual ®...
Page 15
NOTICE launcher only for a CO effect. Place the tube in the barrel. Close the launcher. Make sure to completely close the launcher. Failure to do so WARNING could lead to injury. MAGICFX CO2LAUNCHER — User and Installation Manual ®...
Fill the tube with confetti and/or streamers. The maximum dimensions of the streamers may be 5 m x 0,85 cm or 10 m x 1,5 cm. 16 MAGICFX CO2LAUNCHER — User and Installation Manual ®...
Place an end sticker on top of the tube. Place the tube in the barrel and close the launcher, see Section 3.2, step 5 and 6. SHOOT Carefully walk to the desired shooting position. Unlock the safety catch. MAGICFX CO2LAUNCHER — User and Installation Manual ®...
Page 18
Make sure there are no persons or animals in the direct output of the MAGICFX® CO2LAUNCHER. When it’s time to shoot, squeeze the handle. The faster you squeeze the handle, the faster the projectile exits NOTICE the launcher. MAGICFX CO2LAUNCHER — User and Installation Manual ®...
Enjoy the view. Release the handle to stop shooting. Place the safety catch back in locking position. 3.6 CLEAN UP Close the connected CO cylinder. MAGICFX CO2LAUNCHER — User and Installation Manual ®...
Page 20
Unlock the safety catch. Squeeze the handle to release the remaining pressure. Place the safety catch back in locking position. 20 MAGICFX CO2LAUNCHER — User and Installation Manual ®...
Page 21
Disconnect the CO hose from the Bottle to Hose Connector on the CO cylinder. Remove the CO Bottle to Hose Connector from the cylinder. Store the launcher. MAGICFX CO2LAUNCHER — User and Installation Manual ®...
TROUBLESHOOTING Always contact MAGIC FX if any malfunctions or errors occur that cannot be solved with the instructions as described in this manual. MAINTENANCE To achieve the maximum service life of the MAGICFX CO2LAUNCHER you must regularly ® clean the MAGICFX CO2LAUNCHER and test if it is functioning correctly.
DECLARATION OF CONFORMITY DECLARAT ION OF CONFORMIT Y MAGIC FX B.V. declares as manufacturer and composer of the technical construction file that the product with the following specifications: Name machine : CO2LAUNCHER Type : MFX1170 Serial number : on product...