Crux DKGM-51 Manual
Crux DKGM-51 Manual

Crux DKGM-51 Manual

Radio replacement w/ swc retention and dash kit for gm lan 11-bit

Advertisement

- Retains factory features in select GM LAN 11 Bit vehicles while functioning with an
aftermarket radio.
- Pre-programmed to retain factory Steering Wheel Controls.
- Supports Bose, non-Bose and Y-91 audio systems.
- Retains chime functions.
- Retains front and rear parking sensors.
- EIA color coded wiring for easy installation.
16 and 14 PIN CONNECTORS
CHEVROLET
2007-2010
Cobalt
2006-2011
HHR
2008-2012
Malibu
PONTIAC
2007-2010
G5
2006-2010
Solstice
SATURN
2007-2010
Aura
2007
Ion
2007-2009
Sky
1. DOES NOT support ONSTAR.
GM-51
GM-2A
Module
Harness
24 PIN CONNECTOR
CHEVROLET
2005-2006
2004-2007
PONTIAC
2005-2009
GM-2B
SWC Cables
Harness
1 / 4
Cobalt
Malibu
G6
Antenna
Dash Kit
Adaptor
Rev.041917

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DKGM-51 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Crux DKGM-51

  • Page 1 - Retains factory features in select GM LAN 11 Bit vehicles while functioning with an aftermarket radio. - Pre-programmed to retain factory Steering Wheel Controls. - Supports Bose, non-Bose and Y-91 audio systems. - Retains chime functions. - Retains front and rear parking sensors. - EIA color coded wiring for easy installation.
  • Page 2 SETTING THE AFTERMARKET RADIO BRAND With the key in the off position, set the DIP switches to the corresponding radio listed below. 3.5MM SWC CABLE The GM-51 Module allows for both types of connections: OPTION A is used for ALPINE, CLARION, JVC, and KENWOOD units (Blue/Yellow wire is attached) OPTION B is used for BOSS, DUAL, FAHRENHEIT, JENSEN, POWER ACOUSTIK, PIONEER, SONY and SOUND STREAM units.
  • Page 3 If the vehicle is equipped with a Bose system, the GM-51 has a built-in Bose adaptor that allows the proper audio input gain from the aftermarket radio to the Bose amplifier. To use this feature, plug in the male 8-pin connector on the harness to the GRAY female 8-pin connector on the GM-51 module. The module is also labeled “Bose”...
  • Page 4 A double DIN radio replacement dash kit is included in the kit to make the installation quick and easy. You have the option of installing a Double DIN or two Single DIN radios. The DKGM-51 kit includes: (1) Main trim ring...
  • Page 5 STEERING WHEEL CONTROL BUTTON FUNCTIONS SWC Button SHORT PRESS LONG PRESS PIONEER VOL + Step Increment Continuous VOL + VOL - Step Decrement Continuous VOL - Arrow Up ▲ Preset Up Seek Up Arrow Down ▼ Preset Down End Call Voice Pick Up Call Activate VR/Deactivate VR...
  • Page 6 BOSS Radio SWC Programming SWC Radio Wiring connection SWC Key1 (Brown-wire) connect to Female 3.5 mm Jack - Brown wire SWC Key2 (White-wire) connect to Female 3.5 mm Jack - Brown/White wire SWC GND (Black-Wire) connect to Radio Negative wire (Black) Programming the Radio Press: [SETTING] >...

Table of Contents