Error Messages - Yamaha QY 300 Owner's Manual

Error Messages

Monitor
Illegal Input
Preset Phrase
No Data
MIDI
MIDI Data Error
Checksum Error
Buffer Full
Now Running
Data Exists
Bulk Ignored
DISK
No Disk
Illegal Format
Bad Disk
File Not Found
Write Protected
Disk Full
Illegal File
Can't Change File Name
System
Memory Full
Battery Low
etc.
Now Working
Delete Old Data? (Yes/No)
Can't Undo. OK? (Yes/No)
Improper data was input.
Attempted to change data defining a preset phrase.
There is no data. The job could not be executed.
Received improper MIDI data; the cable may be bad.
Error receiving bulk data (incorrect checksum).
MIDI Receive Buffer was full. All buffer contents cleared.
Cannot receive bulk data while sequence is playing.
Cannot receive bulk data for song that already has data.
Bulk data was received when the system was not in top of song mode.
Only l-song data for the QY10, 20 is acceptable. The received bulk data was not
the correct type.
No disk in drive.
Disk is not in MS-DOS format.
Disk is damaged; cannot read data.
Unable to find the specified file.
Cannot write to disk: the disk's write-protect tab is on.
Cannot write more data to disk: the disk's data capacity (712K) or directory capac-
ity (112) is full.
Attempted to read file type not supported by QY300. (QY300 supports SMF and
ESEQ only.)
Attempted to change existing filename.
The sequencer's memory is full. The sequencer cannot record more data; jobs
cannot execute.
The memory-backup battery is low; memory cannot be backed up.
Restoring internal data. (This message may appear following Power On, immedi-
ately after the Greeting.)
Specified song or file already exists; load/save operation will delete existing data.
Memory is too full to support Undo; execution will be irreversible.
127