UR FOG FAST 01 NEW Installation And Use Manual page 13

14
INSTALLATION AND CYLINDERS EXCHANGE
The cylinders for FAST-series are guaranteed to work until the expiration date indicated on the top.
Expired cylinders should be substituted even if not yet used / exhausted.
It is recommended to return them to your dealer, who will handle the disposal.
When you close the door, the buzzer will make a sound to confirm the tamper is closed.
Attention: Before opening the side doors, make sure the alarm control panel is in "service"
mode, so that the opening of "anti-sabotage or tamper" circuit will not cause any alarm.
Installation and use manual FAST 01 NEW 220V
FOG FLOW DIRECTION
To ensure the right direction to fog flow, it is recommended to insert a
screwdriver of the diameter of the hole and, without forcing, orient the
nozzle in the correct direction.
This allows you to clearly see the direction and keep it in place while
tightening.
To screw and unscrew the nozzle, you should use a pair of pliers in good
condition, to avoid damaging the plating.
Do not overscrew the nozzle, it is sufficient that the Teflon nozzle does not
move.
Do not flow directly on objects or walls less than 2 meters away or to the floor
if it is installed at a height lower than 2.50 meters.
WARNING!! After fog emission and for few minutes, the nozzle is very hot
RISK OF BURNS IF TOUCHED by bare hands
After removing the screws of the door, simply take away the cylinders and
reset the warning light for empty cylinder. After this operation, insert the new
cylinder until you hear the "click" of the plastic support at its top that goes into
the slot, then close the door.
If the cylinder seemed "stuck" in the upper part do NOT with force, make a
pressure with two fingers on the top of the cylinder, such as to lower it. Then
try again to remove it.
If the cylinder does not enter, check if cylinder plate of the motor remains
lifted. If so, see Paragraph 16.
In case only one empty cylinder has to be replaced, it is recommended to
replace it with the full one already in the machine, while a new cylinder will go
to replace the latter.
This in order to ensure proper rotation of the cylinders and to avoid that a
cylinder can remain unused for a long time within the device.
Page 13 of 21