UR FOG FAST 01 NEW Installation And Use Manual page 12

N.B. Before opening side door ensure that the control panel is set to "service", so that the opening of "anti-
sabotage or tamper" circuit does not cause any shooting.
TABLE OF RECOMMENDED SHOOTING TIME, DEPENDING ON m³ TO PROTECT
Shooting time for each cylinder varies depending on ambient temperature and type of nozzle employed.
m³ of fog Seconds of emission
50 From 1 to 3
100 From 2 to 5
150 From 3 to 7
200 From 4 to 9
250 From 5 to 12
300 From 6 to 15
350 From 7 to 18
The value in the first column indicates the volume of the room to be protected, with respective seconds of emission
reported in the second column.
The value in m³ varies depending on the density to be obtained.
Within the second column, the first value allows to get the maximum density recommended to ensure the absence of
any residual, while with the second value you get minimum recommended visibility of about 50 cm, whereas a higher
visibility would make the fog superfluous.
In places where a little residual causes no problems, it is possible to increase the shooting time.
Please note that the higher the fog released, the more the time required to recover visibility. High levels of fog, over
recommended limits, can leave residual.
Any residual generally disappears in 24/48 hours without intervention, otherwise, it is sufficient a damp rag to clean.
If you want to get a visibility of one meter after 60 seconds as required by EN50131-8 standards, which is used as a
reference by all manufacturers of Fog Cannons, you need to double the value reported in M3 column.
Installation and use manual FAST 01 NEW 220V
The following table is drafted considering standard conditions.
m³ of fog
400
450
500
550
600
650
700
Seconds of emission m³ of fog
From 8 to 19 750
From 9 to 20 800
From 10 to 21 850
From 11 to 22 900
Fr om12 to 23 1000
From 13 to 25 1100
From 14 to 28 1200
Seconds of emission
From 16 to 32
From 18 to 36
From 20 to 40
From 22 to 44
From 24 to 48
From 26 to 52
From 28 to 56
Page 12 of 21