Control Panel And Doors - Rangemaster Professional + 100 FX Dual Fuel User's Manual & Installation Instructions

Fig. 6.5
Fig. 6.6
Fig. 6.8
Fig. 6.9

Control Panel and Doors

Avoid using any abrasive cleaners including cream cleaners.
For best results, use a liquid detergent.
The same cleaner can be used on the doors, or alternatively,
using a soft cloth wrung out in clean hot soapy water – but
take care that no surplus water seeps into the appliance.
After cleaning, polish with a dry cloth.
Removing the Left-hand Main Oven Linings
Some of the lining panels can be removed for cleaning. You
will need to remove the shelves before removing the panels.
To remove the oven shelf supports lift until clear of the two
Fig. 6.7
top supporting holes, and the middle fixing screw and pull
outwards (Fig. 6.5).
To remove the side panels, take out the 5 fixing screws on
each side, lift the panel and slide forwards.
To replace the liner, the cut-out section must be at the top of
the liner. Slide the liner towards the back of the oven cavity.
When this is in position you can replace the fixing screws
and then the shelf supports. To do this, insert the top of the
support into the cut-out section, relocating the support
under the lower fixing screw to secure into place.
Removing the Right-hand Oven Shelf Supports
To clean the oven sides, slide out the shelves, unhook the
shelf supports from the oven sides (Fig. 6.6), and lift out.
Refit in reverse, making sure that the bottom of the shelf
supports are inserted into the holes at the bottom of the
oven (Fig. 6.7), prior to hooking the top into position.
Removing the Right-hand Oven Cover Plate
and Reflector Tray
Isolate the electricity supply before carrying out any
thorough cleaning. Allow the cooker to cool.
Once the side supports have been removed (see above) the
cover plate at the bottom of the oven can be taken out by
unscrewing the 2 fixing screws at the back of the oven
(Fig. 6.8).
Lift the cover plate out using the lip at the back, and carefully
lift up and pull forward.
To remove the reflector tray from underneath the element,
gently raise the element and remove the tray from between
the element and the oven front.
When replacing the reflector tray, it is important to push the
tray fully back into position (Fig. 6.9). To do this, gently lift
the element and slide the tray to the back of the oven.
To replace the cover plate, tilt it up at the back to allow it to
go under the front lip of the oven, making sure that the fixing
holes are aligned at the rear of the cooker. Lower into position
and replace the screws.
20