Deckma Hamburg OMD-2008 Instruction Manual page 20

DECKMA HAMBURG GmbH
voltage can be used to supply additional external circuitry, e.g. alarm lamps or
electrical valves.
Please note: any device connected to the pilot voltage output must be rated for
the voltage the instrument is supplied with. Do not use the pilot voltage for driving
motors, heaters or other high load devices. The pilot voltage is intended for alarm
purposes only.
Fig. 5: Connection Example
Close front cover completely after electrical installation. Water inside the
instrument may result in corrosion and malfunction. Alarm contacts description is
in alarm (non-energized) condition.
Note: In case the OMD-2008 EV-FC is installed as replacement to a
MEPC.60(33) approved separator and no "Status Separator" signal is available, a
link across terminal 11 + 12 can be installed. Alternatively a "Status Separator"
signal can be generated from the Separator control, and an auxiliary relay be
operated with this signal. The Contacts of this relay then can operate the
Issue: 25.09.2015 preliminaryInstruction Manual OMD-2008 (All Versions) Page 19 of 28